Trinket
Installing the Driver
|
Preparing Arduino to use the Board
1. Go to Tools...Programmer: 2. Choose USBtinyISP |
3. Go to Tools...Board: 4. Choose Adafruit Trinket 16MHz (or Adafruit Trinket 8MHz (check value on board)) |
Uploading to the Board
- Uploading can only happen when the light on the board is pulsing (slowly blinking)
- Click the upload button and as it's compiling click the reset button on the board to put it in bootloader mode (when the light is pulsing
- If it doesn't work try repeating step 2 so the pulsing starts just before the upload starts